Description
Light with speed meter/horn/battery status
4 light modes: high bright, low bright, flash, fog light
6 horn ring: whistle, alarm, trumpet, didi, jiji, jiujiu
Lithium battery inside, 2-3 hours charge, can use 5-8 hours.
Specification:
Size: 10.5×4.1cm
Weight: approx. 170g
Material: ABSBattery:1500 mah
Lumen: 500-700 lumens
Working time: 5-8 hours
Note:
After the bicycle lights enter the standby state, there is no button and speed signal within 5 minutes, and the system automatiy enters dormancy.
The setting method is at the bottom
Easy Installation
1.Unscrew the magnetic head by hand and install it on the vehicle shelf.
2.Stick the rubber sticker to the receiver.
3.Install the inductor on the front fork in front of the disc brake.
4.The two sensors align and the distance between them must not exceed 3mm.
5.Mount the LED bike light on the handlebars.
Setting method
2 seconds after the power is fully displayed, the display is as shown in A. The upper part is the current battery level indicator, and the lower part is the code table unit setting. The default is metric system. Press the SET button once to switch to the inch system. Press MODE and SET key for 5 seconds at the same time, the system enters soft start, all settings are cleared, and the system repeats the above operation as if it is newly powered on. The display is like the B chart. Press the SET button again and the unit switches to km/h again.
After setting up, To exit The total mileage of the initial setting. The display is as shown in E. The 1238.6 is the initial mileage set number, If there is no set initial mileage The F diagram is displayed.
At this point, all the initial settings of the code table are set and the system enters the standby state.
Bike Tail Details
Battery: 330 mah
Lighting mode: 4 modes
Lumen: 250 lumens
Waterproof: IPX4
Charge time:1-1.5 hours
Working life 4-8 hours
Applicable diameter:12-32 mm
Press 1 second to turn on the light.
